Fulgor Milano radiant cooktop
showing FE / Ft
FE and Ft on the S600 radiant cooktop mean a temperature sensor failure.
Mon–Sat, 8am–8pm
- Temperature and overheat sensors
- Induction board and coil repair
- Source: Fulgor Milano
Book a visit
Three short steps, about a minute.
or call (844) 252-4077
Loading appointment form…
The appointment form couldn’t load. Please try again.
What FE / Ft
actually means.
FE and Ft on the S600 radiant cooktop mean a temperature sensor failure. Fulgor's advice for control errors like this is to remove and restore mains power, and to get service if it persists.
Fulgor Milano cooktop display · also shown as FE, Ft
What to do when FE / Ft shows on the cooktopKind of codeTemperature and overheat sensors
A sensor under the glass or on a board reported a reading the control rejected, or heat climbing past the safe limit — often after an empty pan was left on a zone. The zone is allowed to cool and a loose sensor plug is ruled out before the sensor, the coil assembly or the board is blamed. A top that keeps getting hotter is switched off at the breaker first.
Usually leads toInduction board and coil repair
Induction zones that stop sensing pans, cut out, buzz or show codes, traced to the power boards, the coils, their sensors and the links to the controls.
Shows up asCooktop Element Not Heating
A coil stays black, a radiant ring under the glass never glows, or a zone warms so weakly that a pot of water will not boil.
MakeFulgor Milano
An Italian maker of built-in cooking appliances sold through US luxury dealers.
SourceFulgor Milano S600 radiant cooktop use and care manual (archived)
Fulgor Milano S600 radiant cooktops (F6RT24, F6RT30, F6RT36); read from the archived use and care manual. The display shows F and a second letter in turn, and upper and lower case mean different things.
Before you book,
in this order.
Each step comes from Fulgor Milano's own guidance for FE / Ft on its cooktops. Follow it to the end: the last card says whether this is a visit.
Switch the breaker off, wait, and switch it back on.
Do not open the cooktop to look at the sensor while the power is disconnected.
If FE or Ft returns, book a visit.
Still there?
It usually turns into induction board and coil repair. Book with the code and the model number.
What not to do
FE/Ft is a sensor failure, not an overheated cooktop; that is Fc. Nor is it a key or relay error; the control cannot get a trustworthy temperature reading.
What you may
notice with it.
The cooktop problems FE / Ft tends to arrive with. Answer these at the cooktop before anyone is booked.
All problems
Cooktop Element Not Heating
6 causes, cheapest first
Where FE / Ft usually leads
Induction board and coil repair.
Fulgor Milano
cooktops.
An Italian maker of built-in cooking appliances sold through US luxury dealers.
Fulgor Milano cooktop repairMore Fulgor Milano codes
All 14 Fulgor Milano codesTemperature and overheat sensors on other makes
All 50 codes of this kind
Gas cooktop
A gas cooking surface dropped into a countertop cutout, with its gas line and power cord running down into the cabinet underneath.
Electric cooktop
A coil or smooth-glass radiant cooking surface built into the countertop and wired to its own circuit in the cabinet or wall behind it.
Induction cooktop
A glass cooktop in the counter that heats the pan itself through magnetic coils, run by power boards and cooled by a fan underneath.
In Fulgor Milano's own words
FE, Ft Temperature sensor failure
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Fulgor Milano S600 radiant cooktops (F6RT24, F6RT30, F6RT36); read from the archived use and care manual. The display shows F and a second letter in turn, and upper and lower case mean different things.
Fulgor Milano FE / Ft cooktop repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about FE / Ft.
Can I clear FE / Ft myself?
Will letting the Fulgor Milano cooktop cool clear FE?
Does Ft mean the same as FE on a Fulgor Milano cooktop?
Why does Fulgor say to remove and restore mains power for FE on the F6RT24?
Back to your everyday
Still showing FE / Ft?
Book with the code copied exactly, the full model number, and whether there is any smell of gas or burning — with a code in hand, that is where the diagnosis starts.