The underside of a glass cooktop propped on a workbench with its tray removed, a flat ribbon cable running from the touch board at the front edge to the larger board behind it.

Fulgor Milano induction cooktop
showing Er20

Er20 is a flash failure inside the touch control, meaning its microcontroller is not working correctly.

(844) 252-4077

Mon–Sat, 8am–8pm

  • Boards and communication
  • Touch control repair
  • Source: Fulgor Milano

Book a visit

Three short steps, about a minute.

or call (844) 252-4077

Before you book,
in this order.

Each step comes from Fulgor Milano's own guidance for Er20 on its cooktops. Follow it to the end: the last card says whether this is a visit.

01

Switch the breaker off and on once.

02

Do not keep cycling the breaker; one try is enough to tell whether Er20 clears.

03

If Er20 stays, book a visit for the control unit.

Still there?

It usually turns into touch control repair. Book with the code and the model number.

What not to do

Er20 has nothing to do with the pans or the coils. It is not a sensor or wiring code either; Fulgor places it in the microcontroller of the touch control.

What you may
notice with it.

The cooktop problems Er20 tends to arrive with. Answer these at the cooktop before anyone is booked.

All problems

Where Er20 usually leads

Touch control repair.

Touch control board or key panel · moderate.

In Fulgor Milano's own words

Flash-failure
Fulgor Milano S700 induction cooktop use and care manual (archived) Fulgor Milano S700 induction cooktop use and care manual (archived)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Fulgor Milano S700 induction cooktops (F7IT30S1, F7IT36S1); read from the archived use and care manual. The Enova (F7EIK, F7ECIK) and Sofia induction rangetop manuals were not checked for the same table.

Fulgor Milano Er20 cooktop repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A parent and a teenager stirring a pan together over a gas cooktop set into a kitchen island
For the heart of your home.

Questions
about Er20.

Can I clear Er20 myself?
Switch the breaker off and on once. If it comes back, it needs a visit.
Is Er20 on a Fulgor Milano cooktop caused by a power cut?
A breaker cycle is worth one try, but Fulgor ties Er20 to the control unit itself, which is replaced if the code stays.
Will the other Fulgor Milano zones work with Er20?
The code is in the touch control that runs every zone, so expect the whole cooktop to be affected.
What is a flash failure on a Fulgor Milano S700 touch control?
Fulgor uses the term for Er20, meaning the microcontroller inside the touch control is not working correctly. Because that part sits within the control unit, the listed remedy is to exchange the whole unit.

Back to your everyday

Still showing Er20?

Book with the code copied exactly, the full model number, and whether there is any smell of gas or burning — with a code in hand, that is where the diagnosis starts.

(844) 252-4077 Schedule a repair