Fulgor Milano induction cooktop
showing E2
On the S700 induction cooktop, E2 means the induction coils have overheated.
Mon–Sat, 8am–8pm
- Temperature and overheat sensors
- Induction board and coil repair
- Source: Fulgor Milano
Book a visit
Three short steps, about a minute.
or call (844) 252-4077
Loading appointment form…
The appointment form couldn’t load. Please try again.
What E2
actually means.
On the S700 induction cooktop, E2 means the induction coils have overheated. Fulgor's only remedy is to let them cool, so it is a protective stop rather than a broken part, unless it keeps happening.
Fulgor Milano cooktop display
What to do when E2 shows on the cooktopKind of codeTemperature and overheat sensors
A sensor under the glass or on a board reported a reading the control rejected, or heat climbing past the safe limit — often after an empty pan was left on a zone. The zone is allowed to cool and a loose sensor plug is ruled out before the sensor, the coil assembly or the board is blamed. A top that keeps getting hotter is switched off at the breaker first.
Usually leads toInduction board and coil repair
Induction zones that stop sensing pans, cut out, buzz or show codes, traced to the power boards, the coils, their sensors and the links to the controls.
Shows up asCooktop Element Not Heating
A coil stays black, a radiant ring under the glass never glows, or a zone warms so weakly that a pot of water will not boil.
MakeFulgor Milano
An Italian maker of built-in cooking appliances sold through US luxury dealers.
SourceFulgor Milano S700 induction cooktop use and care manual (archived)
Fulgor Milano S700 induction cooktops (F7IT30S1, F7IT36S1); read from the archived use and care manual. The Enova (F7EIK, F7ECIK) and Sofia induction rangetop manuals were not checked for the same table.
Before you book,
in this order.
Each step comes from Fulgor Milano's own guidance for E2 on its cooktops. Follow it to the end: the last card says whether this is a visit.
Switch the zone off and let the cooktop cool.
Check that nothing is packed against the underside of the cooktop.
If E2 returns during normal cooking, book a visit.
Still there?
It usually turns into induction board and coil repair. Book with the code and the model number.
What not to do
E2 on this cooktop is not a supply or wiring code; that is U400. It is also not the E9 sensor code, because here the coils really did get too hot.
What you may
notice with it.
The cooktop problems E2 tends to arrive with. Answer these at the cooktop before anyone is booked.
All problems
Cooktop Element Not Heating
6 causes, cheapest first
Where E2 usually leads
Induction board and coil repair.
Fulgor Milano
cooktops.
An Italian maker of built-in cooking appliances sold through US luxury dealers.
Fulgor Milano cooktop repairMore Fulgor Milano codes
All 14 Fulgor Milano codesTemperature and overheat sensors on other makes
All 50 codes of this kind
Gas cooktop
A gas cooking surface dropped into a countertop cutout, with its gas line and power cord running down into the cabinet underneath.
Electric cooktop
A coil or smooth-glass radiant cooking surface built into the countertop and wired to its own circuit in the cabinet or wall behind it.
Induction cooktop
A glass cooktop in the counter that heats the pan itself through magnetic coils, run by power boards and cooled by a fan underneath.
In Fulgor Milano's own words
Overheating of the induction coils
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Fulgor Milano S700 induction cooktops (F7IT30S1, F7IT36S1); read from the archived use and care manual. The Enova (F7EIK, F7ECIK) and Sofia induction rangetop manuals were not checked for the same table.
Fulgor Milano E2 cooktop repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about E2.
Can I clear E2 myself?
Why does my Fulgor Milano cooktop show E2 during a long boil?
Can I restart a Fulgor Milano zone right after E2?
Does E2 on a Fulgor Milano F7IT36S1 mean a coil needs replacing?
Back to your everyday
Still showing E2?
Book with the code copied exactly, the full model number, and whether there is any smell of gas or burning — with a code in hand, that is where the diagnosis starts.