A hand wiping a puddle of spilled water off the touch-key strip of a black glass cooktop set into a counter, the slider keys glowing faintly beneath the drops.

Thermador cooktop
showing F5

F5 is a warning that a pan sits too near the touch controls.

(844) 252-4077

Mon–Sat, 8am–8pm

  • Touch controls and keys
  • Touch control repair
  • Source: Thermador

Book a visit

Three short steps, about a minute.

or call (844) 252-4077

Before you book,
in this order.

Each step comes from Thermador's own guidance for F5 on its cooktops. Follow it to the end: the last card says whether this is a visit.

01

Slide the pan away from the controls; if the zone went off, wait a few seconds and touch any control.

02

Keep oversized pans on the rear zones so their edges stay clear of the control area.

03

Book a visit if F5 appears with the control area clear.

Still there?

It usually turns into touch control repair. Book with the code and the model number.

What not to do

F5 does not mean a key is broken or that the glass is cracked. It is a heat warning about where the pan is sitting.

What you may
notice with it.

The cooktop problems F5 tends to arrive with. Answer these at the cooktop before anyone is booked.

All problems

Where F5 usually leads

Touch control repair.

Touch control board or key panel · moderate.

In Thermador's own words

There is hot cookware near the control panel. The electronics are at risk of overheating.
Thermador induction cooktop error codes (US support)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Listed on Thermador's induction and electric cooktop pages.

Thermador F5 cooktop repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A parent and a teenager stirring a pan together over a gas cooktop set into a kitchen island
For the heart of your home.

Questions
about F5.

Can I clear F5 myself?
Slide the pan away from the controls; if the zone went off, wait a few seconds and touch any control. If it comes back, it needs a visit.
Why does my Thermador beep and show F5 when I use the front zone?
A large pan on a front zone can overhang the controls. Center it on the zone, or use a rear zone for oversized pans.
Do I have to reset anything after F5?
Only touch a control once the pan is moved. No breaker reset is needed.
What is the difference between a flashing power level and a plain tone with Thermador F5?
If the power level keeps flashing and a tone sounds, the zone is still on and Thermador is warning you. If only the tone sounds, the zone has already switched off to protect the electronics. Moving the pan is the fix in both cases.

Back to your everyday

Still showing F5?

Book with the code copied exactly, the full model number, and whether there is any smell of gas or burning — with a code in hand, that is where the diagnosis starts.

(844) 252-4077 Schedule a repair